23
Water Connection
This appliance is designed to be permanently
plumbed into your home's water supply and drai-
nage system.
Water Inlet
Please install the water inlet hose onto the back
of your washing machine :
- Insert the seal in the hole at the bottom of the
back panel (fig. 1).
- Screw on the bottom fitting of the water inlet hose
as shown in fig. 2 and fig. 3.
- Connect the feed hose connector onto the water
inlet tap, taking care to position the gasket
correctly.
- Turn on the water inlet tap.
The water inlet hose cannot be extended. If it is
too short, please contact the After Sales
Department.
Water Drainage
- Assemble the hose holder onto the drain hose.
- Place the assembly in a drainage pipe at a height
between 70 and 100 cm. Make sure that it will not
fall out.
If you intend the drain hose from the washing
machine to empty into a sink, make sure that the
sink is empty and that the plug hole is not blocked.
Use the plastic "U-piece" supplied. The "U-piece"
also has a retaining eye to secure the outlet hose
and prevent it from slipping off its location. The
force of draining water may force the hose out of
the sink.
