38
1. Check the filters
Ensure they are clean and properly positioned
(see "Maintenance and cleaning").
2. Press the On/Off push button
The On/Off indicator light will illuminate.
Three horizontal lines (---) will appear in the
digital display.
3. Check that there is rinse aid
and salt
The corresponding indicator lights will
illuminate if refilling is necessary.
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the
plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5. Ensure that the spray arms
can rotate freely.
6. Measure out detergent
Add the required amount of detergent into the
dispenser.
Important!
If the "half load" option is selected
remember to reduce the quantity of
detergent.
Close the detergent dispenser lid.
The setting of the progamme is possible:
With the door open, in this case the selected
programme and eventual options will start
automatically 5 seconds after closing the
dishwasher’s door.
With the door closed, in this case the
selected programme and eventual options will
start automatically 5 seconds after the last
pressure of a push button.
7a. Setting and starting the
programme without "delay
start"
Press the push button corresponding to the
required programme, all the phase indicator
lights for that programme illuminate.
In the digital display appears the time duration
of the programme (in minutes).
Select if necessary the washing of only a few
dishes by pressing the "half load" push
button.
In this case there will be, in the digital display,
a conforming of the time duration.
Remember to load all dishes into both
baskets.
If the setting has been done with the door
open,
close the dishwasher’s door and the
programme will start automatically after 5
seconds.
Until the door remains opened you still have
the possibility to change the washing
programme and select or cancel the half load
option
If the setting has been done with the door
close,
the programme will start automatically after 5
seconds from the last pressure of a push
button.
The start of the washing programme will be
confirmed by an audible signal, the phase
indicator lights turn off except for the indicator
light of the current phase.
The time duration of the programme, in the
digital display, will start to decrease from
minute to minute.
7b. Setting and starting the
programme with "delay start"
Once a programme and required options
have been selected (see point 7a.) to use
"delay start" proceed as follows:
Press the "delay start" push button.
In the digital display will appear "h 1".
Press the push button again to select the
number of hours by which you wish to delay
the start of the programme (up to a maximum
of 12 hours)
Operating sequence
