8825/8830 Controller Setup Manual for Firmware 6.0 108
Configuring the Printer Processing Defaults (continued)
Setting the Media Type Set Option
Media Type Option Purpose
This option sets the default type of media that will be used for all jobs.
Range: BOND, VELLUM, FILM, or ANY
Default: BOND
Note: If a job is sent to the printer and the desired media type is not installed,
the user will be prompted to load the correct media type.
PATH TO MEDIA TYPE OPTION
Display <IDLE>, press [ON-LINE], display <PAUSED>, press [ENTER],
display <UTILITIES>, pr
ess [NEX
T] until <PRO
CESSING DEFAULT
S> is
displayed, press [ENTER], display <ELECTRONIC COLLATION>, press
[NEXT] until <MEDIA TYPE> is displayed.
SELECTING THE MEDIA TYPE OPTION
Press the ENTER key to change the option. Press the NEXT key to toggle
through the selections, and when the desired selection is displayed, press the
ENTER key.
EXITING THE MEDIA TYPE OPTION
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.
