PROBLEM SOLVING TASKS
12-26 XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
System controller problems
This section explains what to do when one oft he following problems
occur:
• LPS does not boot
• Printer does not respond to the sytem controller
• Blank display on the system controller terminal
• Rasterization messages appear in the Messages window of the
PC UI or on the system controller display
LPS does not boot (system controller terminal)
If you have followed the procedure for powering on and booting the
LPS, but the system does not boot properly:
Step 1. Press the <CAPSLOCK> key on the system controller keyboard.
Step 2. Press the Boot button on the operator control panel (see figure 12-
34).
Figure 12-34.Boot button on the operator control panel
Step 3. Reenter the BOOT command.
If the system still does not boot, call for service.
Printer does not respond to system controller
If the printer control console displays PRESS CONTINUE TO
RESUME PRINTING, but the printer does not respond when you
press the Continue button, or if the printer does not respond to
directions from the PC UI or the system controller keyboard (non-U.S
markets only), they may have lost communication with each other.
Use the following procedure to restore the communication between
the system controller and printer.
Step 1. Press the Continue button on the printer control console, if directed
to do so.
Note: If the printer responds and resumes printing, do not
follow the rest of this procedure.
