Dil ID: 6
Dil Adı: turkish
Dil Kodu: tr2tayfun Whirlpool Markası'nın Ürünleri
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



Connect the water supply hose(s) (A or B, depending
on the model)
If your washing machine has one inlet hose and one inlet
valve on the back: connect to cold water supply (“C”) only.
If your washing machine has two inlet hoses and two
inlet valves on the back: connect to cold (“C”) and hot
(“H”) water supply, or to cold water supply only by
using the Y-piece connector. Both inlet valves must be
connected to the water supply. Observe the detailed
instructions in your programme chart.
1.
Carefully screw the hose connection onto the tap,
preferably by hand.
2.
Make sure there are no kinks in the hose.
3.
Check water-tightness of tap and appliance connections by
turning the tap completely on.
The appliance
must not be
connected to the mixing tap of a
non-pressurized water heater.
The appliance can be connected without a non-return valve.
If the flexible hose is damaged, unplug the appliance from
the mains immediately.
If the hose is too short, replace it with a longer length of
“Water Stop” hose (available from After-Sales Service or
specialist dealer).
Mount the new hose professionally on the washing machine
and the tap.
Note that the Aquastop/Water Stop safety function is no
longer guaranteed once the hose coating is damaged.
Connect the water drain hose
1.
Connect the drain hose to a ventilated siphon or to a
standpipe. For fixing the drain hose to a standpipe, use the
“U-bend” delivered with the washing machine (picture
C
”). - Make sure that the hose is firmly fixed and that there
are no kinks.
If you need to add an extension, use a hose of the same type.
Secure the connections with clips.
Max. drain hose length: 2.50 m
Max. drain height: 1.25 m
Min. drain height: 0.70 m
Safety valve
inspection
window
A
B
C