INSTALLATION
Remove the transit bolts
1.
Slacken the four bolts with the spanner supplied.
2.
Unscrew the bolt by hand.
3.
Grip the bolt and remove it through the large aperture.
4.
Seal the resulting holes using the plastic caps supplied.
To do this, insert the caps in the wide part of the hole
in the direction of the arrow and push them into the
narrow groove until they click into place.
5.Keep the transit bolts for future use.
•
Whenever the appliance is transported, the transit bolts
must be refitted:
1.
Raise the plastic covers with a screwdriver, slide them
in the opposite direction of the arrow and remove.
2.
Insert the transit bolts in the reverse order.
Adjust the feet
Small unevennesses in the floor can be compensated for
by screwing the four appliance feet up or down (never use
pieces of wood, cardboard or similar material):
1.
The washing machine must be installed horizontally in
width and depth. Use a spirit level.
2.
Loosen the locknut clockwise using the wrench
provided.
3.
Adjust the height of the feet by hand; take care not to
to screw out the feet by more than 20 mm.
4.
Tighten the locknut anti-clockwise to the washing
machine.
If the appliance is to be installed on a wooden floor,
distribute the weight by placing it on a 70 x 70 cm sheet
of plywood at least 3 cm in thickness.
Screw the plywood sheet to the floor.
Remove transit bolts - 1.
Remove transit bolts - 3.
Remove transit bolts - 4.
Adjust feet - 2.
Adjust feet - 3.
max. 20 mm
Adjust feet - 4.
