91
WATER SUPPLY
•
Water supply: only cold water.
•
Tap: 3/4" threaded hose connector.
•
Water pressure (mains pressure): 10-100 N/cm
2
(1-10 bar).
INLET HOSE(S)
1.
Insert the mesh filter supplied in the thread on the
end of the inlet hose(s) and the tap(s).
2.
Carefully screw the inlet hose(s) to the tap(s)
preferably by hand, taking care that the hose is not
kinked.
3.
Turn the tap(s) on fully and check that the joints at
the washing machine and the tap(s) are watertight.
•
If the hose is not long enough, replace it with a
suitable length of pressure-resistant hose
(approved under EN 500 65 to withstand a
minimum of 10 bar).
•
Check the hose regularly for brittleness and cracks
and replace if necessary.
•
The washing machine may be connected without a
non-return valve.
•
Observe any special local regulations regarding
connection to the water supply.
WATER STOP (depending on model)
•
The inlet hose and the plastic enclosure at the
water connection contain electrical components.
•
Do not cut the flexible hose and do not immerse
the plastic enclosure in water.
•
If the hose is damaged, unplug the appliance from
the mains immediately.
•
If the hose is not long enough, replace it with a 3 m
long Water Stop hose (available from After-Sales
Service or a specialist dealer). This must be done
only by a qualified electrician.
INSTALLATION INSTRUCTIONS
