At the end of a washing program the But-
ton lock function is deactivated by opening
and closing the door or switching off the
appliance.
Important! It is not possible to deactivate
the Button lock function while a washing
program is in progress. To do this you must
cancel the set program. Refer to 'Select
and start a washing program'.
Setting mode
The appliance is in setting mode when all
the program indicators are on.
The appliance must be in setting mode to
set a washing program.
If a program indicator is on, cancel the pro-
gram to go back to the setting mode. Refer
to 'Select and start a washing program'.
USE OF THE APPLIANCE
Refer to specified instructions for each step
of the procedure.
1. Fill the rinse aid dispenser with rinse aid.
2. Load cutlery and dishes into the appli-
ance.
3. Set the correct washing program for the
type of load and soil.
4. Fill the detergent dispenser with the cor-
rect quantity of detergent.
5. Start the washing program.
USE OF RINSE AID
Caution! Only use rinse aid specified
for dishwashers.
Do not fill the rinse aid dispenser with
other products (e.g. dishwasher clean-
ing agent, liquid detergent). This can
cause damage to the appliance.
Rinse aid makes it possible to dry the
dishes without streaks and stains.
Rinse aid is automatically added during
the last rinsing phase.
Follow these steps to fill the rinse aid dis-
penser:
1. Press the release button (A) to open the
rinse aid dispenser.
2. Fill the rinse aid dispenser with rinse aid.
The mark 'max.' shows the maximum
level.
3. Remove the spilled rinse aid with an ab-
sorbent cloth to prevent too much foam
during the subsequent washing pro-
gram.
4. Close the rinse aid dispenser.
Adjusting the rinse aid dosage
The rinse aid is set at the factory at position
4.
You can set the rinse aid dosage between
position 1 (lowest dosage) and position 6
(highest dosage).
6 westinghouse
