5
802.11g 54Mbps USB Adapter Installation
Prepare for Installation
ATTENTION: You must install your software and drivers before you physically connect the 802.11g
54Mbps USB Adapter.
Note: For the most updated information, visit: http://www.usr.com/support
Turn on your desktop or laptop computer. Type your password if you are prompted to do so.
Note: Be sure to find out what letter your CD-ROM drive uses before you begin installing
your new product. You will need to know this to properly install your software.
Note: During the Installation procedure, you may be prompted for your Windows Operat-
ing system CD-ROM. Make sure you have it available in case you need it.
Note: If the 802.11g 54Mbps USB Adapter does not fit into an available USB port on your
computer because of other USB devices that are connected, use an USB extension cable
or a USB hub to connect the 802.11g 54Mbps USB Adapter.
Note: If you are connecting the 802.11g 54Mbps USB Adapter to a 1.1 USB port, you may
see a message informing you that a Hi-Speed USB device is being connected to a USB
port that is not Hi-Speed. This will not affect the installation procedure.
Step One: Install your software and drivers
Insert your U.S. Robotics Installation CD-ROM into your CD-ROM drive.
Note: If your CD-ROM does not automatically launch, click Windows Start, Run, and type
D:\setup (if your CD-ROM drive uses a different letter, type that letter in place of "D") and
click OK.
The Installation CD Graphic User Interface (GUI) will appear on your screen. If prompted, select
Model Number Serial Number
USR5422
