02
Load Balance Broadband Router
Interface Description
Interface Description
WAN
The WAN port is designed to connect the router to the interface provided
by ISP via the RJ45 cable
LAN
The LAN port is designed to connect the router to the local PCs or
switches by the RJ45 cable
Console
The Console port is designed to connect with the serial port of a computer
or terminal to check and monitor some simple system information of the
router
Reset
With the router powered on, use a pin to press and hold the Reset button (about 5
seconds) until the SYS LED ashes quickly. Then release the button and wait for the
router rebooting to its factory default settings.
■
Rear Panel
The rear panel of TL-R480T+ is shown as the following figure.
Figure 1-2 Rear Panel
Power Socket
Connect the female connector of the power cord here, and the male connector to
the AC power outlet. Please make sure the voltage of the power supply meets the
requirement of the input voltage.
Grounding Terminal
The router already comes with lightning protection mechanism. You can also ground
the router through the PE (Protecting Earth) cable of AC cord or with Ground Cable.
For detailed information, please refer to Chapter 3 Lightning Protection.
Caution: Please use the provided power cord.
Introduction
