
Before using for the first time
Salt indicator
When the salt reservoir is empty, the
"Salt-PC" indicator will light, indicating
that it should be refilled with
reactivation salt.
& Pans
omy
O Intake/Drain O Rinse
O Rinse aid O Drying
O End
Start/
O lop Solo O Stop
Bypassing the saJt indicator
If your water is soft (below 8 gr/ga!) the
salt reservoir should not be filled with
salt. The indicator will remain lit and
should be disregarded or bypassed.
[] Remove the salt reservoir cap.
Looking into the salt reservoir, you will
see the top of the float chamber on the
right hand side, '_.
After the reservoir has been filled, the
water softener is automatically
reactivated the next time the
dishwasher is started. The "Salt"
indicator will be lit during this process.
[] Using a screwdriver, carefully pivot
the float chamber towards the center
of the reservoir,
[] Using needle nose pliers, pull the
cap, _, off of the float chamber, and
remove the float, '_@.
Replace the float chamber cap, push
the chamber back into its upright
position, and replace the salt reservoir
cap. The "Salt" indicator should no
longer be lit.
18