8
16- Once the breathers are secure, install the fuel line per the factory service manual you are working with. Connect the battery and verify the fuel
pump turns on to pressurize the system and there are no gas leaks, but DO NOT START THE ENGINE. At this time, PC software may also be used
to verify sensor readings and adjust the throttle position sensor voltage if necessary.
17- Install two 242 Loctite® coated pipe plugs (included in kit) in the air cleaner backplate as shown in Picture 16. Torque to 35-45 in-lbs. Also, two
pan screws coated with Loctite® 222 must be installed in the backplate in place of the enrichment device. See Picture 16a. Torque them to
12-18 in-lbs. Failure to install these screws could allow dirt and debris into the intake system.
18- Use a new gasket on the backplate and put it in place noting the number of shims required. Once you select the appropriate shims (included)
mount the backing plate to the engine but DO NOT INSTALL THE SCREWS YET.
Picture 16a
Picture 17
Picture 16
