
•
Press button 9 again.
The Delay Start cannot be selected with the
draining programme.
Start the programme
To start the selected programme, press the
button 9 ; the green pilot light stops flashing.
If you have selected a delay time, the
countdown will begin and will be shown on
the display.
To interrupt a programme which is running,
press button 9 : the green pilot light starts to
flash. To restart the programme from the
point at which it was interrupted, press the
button 9 again. If an incorrect option is
selected, the red pilot light of button 9 flashes
3 times and the message Err is displayed for
a few seconds.
Important!
You must set the washing machine to Pause
before you make any change in the
programme in progress.
How to change an option
or a programme during
its cycle
It is possible to change some options
before the programme carries them out.
Before you make any change, you must pause
the washing machine by pressing the button
9 . Changing a running programme is possible
only by resetting it .
Turn the programme selector dial to «Off»
and then to the new programme position.
Start the new programme by pressing the
button 9 . The washing water in the tub will
not empty out
How to interrupt a
programme
Press the button 9 to interrupt a programme
which is running, the corresponding green
pilot light starts blinking.
Press the same button again to restart the
programme.
How to open the door
during the cycle of a
programme
You can open the door, after having set the
washing machine to Pause, provided the
following conditions exist:
• The washing machine is not in the heating
phase
• The level of the water is not high;
If these requirements are met, when you
pause the washing machine, the «Door lock»
light goes off and the door can be opened.
Should it not be possible to open the door,
and should it be absolutely necessary to do so,
switch the machine off by turning the selector
dial to Off . After a few minutes, you can open
the door.
Pay attention to the level and
temperature of the water in the
washing machine! When you close the
door to restart the programme turn the dial
to the previous programme and repeat the
options previously selected and press button
9 .
End of programme
At the end of the programme, the washing
machine stops automatically, the button 9
light and the Door lock light go off. The
display shows a flashing zero «0». It is possible
to open the door.
15