- Keep the appliance and its cable out of
the reach of children.
Caution
- Only use the adapter or a USB port
(e.g. computer) to charge the appliance.
- Do not use the shaver, the adapter or
the USB cable if it is damaged.
- If the adapter or the USB cable is
damaged, always have it replaced with
one of the original type in order to avoid
a hazard.
- Charge, use and store the shaver at a
temperature between 5°C and 35°C.
- Do not use the shaver in combination
with pre-shave lotions, creams, foams,
gels or other cosmetic products.
Compliance with standards
- This Philips appliance complies with all
standards regarding electromagnetic elds
(EMF). If handled properly and according
to the instructions in this user manual, the
appliance is safe to use based on scientic
evidence available today.
- This shaver complies with the
applicable IEC safety standards.
Charging
Note: Charge the appliance when the motor
stops or starts running slower.
The shaver can be charged with the adapter
or the USB cable supplied with the appliance.
Make sure the shaver is switched off when
you start to charge it.
When you charge the shaver for the rst
time or after a long period of non-use, let it
charge continuously for 12 hours. Charging
normally takes approx. 8 hours.
For optimal performance, only charge the
shaver when the battery is low.
Do not leave the appliance connected to the
mains or USB port for more than 24 hours.
1 Put the micro USB plug in the
shaver (Fig. 3).
2 Put the adapter in the wall socket or
put the USB cable into a USB port
(e.g. computer) (Fig. 4).
, The charging light goes on to indicate
that the appliance is charging (Fig. 5).
Note: Charge the shaver for at least 8 hours
but not more than 24 hours.
ENGLISH
Introduction
Congratulations on your purchase and
welcome to Philips! To fully benet from
the support that Philips offers, register your
product at www.philips.com/welcome.
General description (Fig. 1)
1 Protection cap
2 Shaving heads
3 Shaving unit
4 Retaining frame
5 Cutter
6 Guard
7 Shaving unit release button
8 On/off slide
9 Shaver
10 Charging light
11 Socket for micro USB plug
12 Adapter
13 Micro USB plug
14 USB cable
15 Cleaning brush
16 Shaver storage pouch
Important
Read this user manual carefully before you
use the appliance and save it for future
reference.
Danger
- Warning: Keep the appliance, the
adapter and the USB cable dry.
- This symbol means: Forbidden to clean
under a running tap (Fig. 2).
Warning
- The adapter contains a transformer.
Do not cut off the adapter to replace
it with another plug, as this causes a
hazardous situation.
- Warning: Do not use this appliance
close to a bathtub, shower or other
containers lled with water.
- Check if the voltage indicated on the
adapter corresponds to the local mains
voltage before you connect the appliance.
- This appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning
use of the appliance by a person
responsible for their safety.
3 When the battery is fully charged,
remove the micro USB plug from the
shaver. Then remove the adapter from
the wall socket or the USB cable from
the USB port (Fig. 6).
Note: You cannot use the shaver when it is
connected to the mains or a USB port. When
the battery is empty, you have to recharge the
battery before you can use the shaver again.
Cordless shaving time
A fully charged shaver has a cordless shaving
time of approximately 30 minutes.
Using the appliance
Note: The shaver cannot be used when it is
connected to the mains or a USB port.
Shaving
1 Remove the protection cap.
2 Press the travel lock (1) and push the
on/off slide upwards (2) to switch on
the shaver (Fig. 7).
3 Move the shaving heads quickly over
your skin. Make both straight and
circular movements (Fig. 8).
Shaving on a dry face gives the best results.
Your skin may need 2 or 3 weeks to get
accustomed to the Philips shaving system.
4 After use, push the on/off slide
downwards to switch off the shaver.
5 Put the protection cap on the
shaver every time you have used
it, to prevent damage and to avoid
dirt accumulation in the shaving
heads (Fig. 9).
Cleaning and maintenance
Never use scouring pads, abrasive cleaning
agents or aggressive liquids such as petrol
or acetone to clean the appliance.
Regular cleaning guarantees better shaving
performance.
For the best cleaning results, we advise you
to use Philips Cleaning Spray (HQ110).
You can also clean the shaver in the following
way:
HS199, HS198
Register your product and get support at
www.philips.com/welcome
4222.002.5435.1
1
2 3 4
5 6 7
8 9 10
11 12 13
14 15 16
17 18 19
20 21 22
23 24 25
