SmartDispense :MDetergent Dispenser
Water Hardness Calibration
Priorto the first use,the dishwasher needsto
be calibrated for water hardness. Pleasefollow
directions below to calibrate the dishwasher to
the hardness of gour tap water.
Determine the Hardness of Your Tap Water
In the bag containing these instructions, gou should
find a water hardnesstest strip package. Readthe
instructions on the package, remove the test strip and
follow the instructions to determine the hardness level
of gour tap water. Youwill use this information to
calibrate gour dishwasher to dispensethe optimal
amount of detergent.
Waterhardnesstest strip indication
Value to Enter
into Dishwasher
SOETOREDI I I I I I I I I 1
1REDI I I I I I I I 2
2 RED _ 3
3 RED _ 4-
HARD 4 RED _ 5
Set Control to Calibration Mode
From the standby mode (dishwasher not running
a cycle and the panel lights on),enter the water
hardness selection mode.
Control Calibration
Control Panel
Pressat the same time for 3 seconds. Displag
1. Closeand latch the door (lightson, dishwasher
not running).
2. Pressthe COOKWAREand DELAYpads at the
same time for 3 seconds.The displag will show a
number 1to 5.This is the water hardnessvalue
currentlg set.
Control Panel
pad to lower pad to raise the
the value, value.
3. Pressthe COOKWAREpad to raise the value or the
NORMALpad to lower the value. Setthe water
hardnessvalue (1to 5)to the number determined
with the test strip and table at left.
4. Once the water hardness is set, pressthe
START/RESETpad to save the setting and return
the dishwasher to normal operation.
You should recalibrate the dispenser if water
conditions change,for example, if a water softener
sgstem is added or removed.
