Cisco Markası'nın Ürünleri

10 Second-Generation Channel Interface Processor (CIP2) Installation and Conﬁguration

CIP2 Installation Prerequisites

If the installed ECA is the earlier ECA, then hw version 01 (or hw version 00) is displayed, as

shown following:

(additional text omitted from this example)

—> ECA0: hw version 01, microcode version C50602C3

Note If you determine that you have the latest ECA (and hw version 02 is displayed), you must

observe and comply with the ESCON channel adapter software and microcode prerequisites; refer

Table 2 and the section “ESCON Channel Adapter Software, Hardware, and Microcode

Prerequisites.”

If you determine that you have the earlier ECA (hw version 00 or hw version 01 is displayed), no

further action is required.

If you see the following error messages displayed, this indicates that you must upgrade the

Cisco IOS software and CIP2 microcode by observing and complying with the ESCON channel

adapter Cisco IOS software and microcode prerequisites; refer to Table 2 and the section “ESCON

Channel Adapter Software, Hardware, and Microcode Prerequisites.”

%CIP2-0-MSG: %ADAPTER-0-DIAGFAIL: Port 0 failed the I/O chip tests diagnostic

%CIP2-0-MSG: %ADAPTER-0-DIAGDATA: Module Call: 123 Error ID: FF85

If you see the following error messages, your Cisco IOS software and CIP2 microcode support the

latest ECA installed in your system:

%CIP2-0-MSG: %ADAPTER-0-DIAGFAIL: Port 0 failed the Electrical wrap diagnostic

%CIP2-0-MSG: %ADAPTER-0-DIAGDATA: Module Call: 1221 Error ID: FE14

Note Running CIP2 microcode versions earlier than cip21-11 and cip22-12 with the latest ECA,

will always result in error messages. Running CIP2 microcode versions earlier than cip21-14 and

cip22-15 with the latest ECA, might result in error messages.

Safety Guidelines

This section lists safety guidelines you should follow when working with any equipment that

connects to electrical power or telephone wiring.

Safety Warnings

Safety warnings appear throughout this publication in procedures that, if performed incorrectly, may

harm you. A warning symbol precedes each warning statement.

Warning Means danger. You are in a situation that could cause bodily injury. Before you work on

any equipment, be aware of the hazards involved with electrical circuitry and be familiar with

standard practices for preventing accidents. To see translations of the warnings that appear in this

publication, refer to the Regulatory Compliance and Safety Information document that accompanied

this device.