15
Gateway fitting list
On entering diagnosis mode, a detailed list
containing the control units fitted in the
vehicle and their current status is read out
from the data bus diagnostic interface. The
gateway fitting list can be displayed in the
self-diagnosis main menu or via assisted
fault-finding. The fitting list (also referred to
as configuration table) shows whether all
control units have been properly encoded, as
well as their fault status.
SSP287_012
Control element test
The following control element tests are
available in the data bus diagnostic interface
as part of assisted fault-finding:
– Start of ring fault diagnosis (refer to
SSP 286, Page 41)
– Start of ring fault diagnosis with dB
reduction (refer to SSP 286, Page 43)
– Transmission of sleep command
VAS display Significance
OK Communication OK
Not
obtainable
The control unit is registered
(encoded) in the gateway but
there is no communication
with it
Fault A fault entry has been stored
in the control unit
Not
registered
The control unit is not
registered in the gateway
(not encoded), but it has
been fitted/there is
communication with this
control unit
On transmitting the sleep command by way
of the final control diagnosis (terminal 15
must be off), the drive system CAN and
convenience CAN are switched to sleep mode
by the data bus diagnostic interface.
Switching of the convenience CAN to sleep
mode is however only possible if no other
control unit is keeping the bus awake, for
example on account of a fault.
If, for example, a control unit has been fitted
but not encoded, this is indicated in the
fitting list as "Not registered". If a control unit
has been encoded, but there is no
communication with it, this may be due to a
fault or non-installation. This control unit is
then labelled "Not obtainable".
Vehicle self-diagnosis
Gateway fitting list
Audi V05.02 18/06/2002
Audi A8 2003>
2003 (3)
Saloon
BFM 4.2l Motronic / 246 kW
01 - Engine electronics OK
61 - Battery control Fault
02 - Gearbox electronics OK
42 - Driver's door electronics Fault
52 - Front passenger's door electronics OK
62 - Rear left door electronics Fault
72 - Rear right door electronics Fault
03 - Brake electronics Fault
53 - Parking brake Fault
34 - Adaptive suspension OK
05 - Entry and start authorisation OK
15 - Airbag Fault
55 - Headlight range control Fault
Measurement Jump Print Help
Communication link
