4. Carefully close the detergent drawer.
10.4 Bleach
Alternatively the softener, it is also
possible to use a bleach agent in the
compartment with the programmes
for white cottons.
Proceed as follows:
1. Put the bleach in the compartment
.
Do not exceed the «MAX» mark in the
detergent dispenser drawer.
2. Run a programme for white cottons.
3. At the end of the programme, run
the programme RINSE. Use softener,
if desired.
This helps to eliminate any bleach
residues.
Never pour bleach and
softener into the
compartment at the same
time.
10.5 Setting a programme
1. Turn the programme knob to switch
the appliance on and set the
programme:
• The indicator of the button
flashes.
• The display shows the
programme duration.
2. If necessary, change the temperature
and the spin speed or add available
options. When you activate an
option, the indicator of the set
option comes on.
Autosense function
At the start of the programme, During
the washing phase the programme
duration is automatically calculated and
can be greatly reduced if the laundry
load is lower than the maximum load
capacity. (e.g. Cotton 30° programme ,
maximum load capacity 7 kg , the default
programme duration exceeds 2 hours, in
case of actual load 2 kg, the program
duration will be reduced to only 1 hour
20 min).
10.6 Starting a programme
without the delay start
Press the button .
• The indicator of the button
stops to flash and stays on.
• The programme starts, the door
locks, the indicator is on.
• The programme time decreases
with steps of one minute.
The drain pump can operate
for a short time at the
beginning of the washing
cycle.
10.7 Starting a programme
with the delay start option
1. Press the button Delay Start again
and again until the display shows the
delay you want to set. The delay start
indicator comes on.
2. Press the button Start/Pause
:
• The door is locked and the
indicator is on.
• The appliance starts the
countdown.
• When the countdown is
completed, the programme starts
automatically.
www.aeg.com
14
