Dil ID: 6
Dil Adı: turkish
Dil Kodu: tr2tayfun AEG Markası'nın Ürünleri
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



Operating Instructions
26
Abort program
0 To abort the washing program prematurely, turn the program selector
to I (OFF).
3
With the button O/s (START/PAUSE), it is possible to interrupt the
washing program at any time and to continue it by pressing the button
again.
The washing cycle is finished/Remove the washing
After a washing program has ended, L (END) lights up on the program
sequence display.
3
The washing machine switches itself into the stand-by mode if no but-
ton is pressed or the program selector is not turned within approx. 3
minutes after the end of the program. Only L (END) is illuminated
from behind. All other displays on the control panel are switched off in
order to save energy. Pressing any arbitrary button cancels the stand-by
mode.
If the program < (EASY IRON) was selected, an anti-crease phase
of approx. 30 minutes follows the program end. The multidisplay
shows a remaining time and the display L (END) lights up. During
the anti-crease phase, you can open the door at any time and remove
the washing.
If the spin speed 0 (Rinse Hold) was selected, O/s (START/PAUSE)
flashes.
0 1. After a rinse hold, it is first necessary to pump off the water:
– Either press the button O/s (START/PAUSE) (water is pumped off
and the washing is spun according to the completed program; With
the button K (SPIN SPEED,) it is also possible to still change the spin
speed during spinning), or
– Turn the program selector to C (PUMP OUT) and press the button
O/s (START/PAUSE) (the water is pumped off without spinning), or
– Turn the program selector to D (SPIN) or F (GENTLE SPIN) and press
the button O/s (START/PAUSE) (the water is pumped out and the
washing is spun or gently spun).
After the end of this program step L (END) is illuminated from the
rear.