Operating Instructions
24
Start the washing program
0 1. Check that the water valve is open.
2. Start the washing program: Press the button O/s
(START/PAUSE). The washing program is started or it
starts after the set time expires.
3
If
K
/W (DOOR/LIGHT) flashes red when the button O/s (START/
PAUSE) is pressed, the door is not properly closed. Press the door firmly
closed and press the button O/s (START/PAUSE) again.
If the time preselection is set:
The set time delay runs. The remaining time until the program start is
shown in the Multidisplay (always in full hours). During this time you
can load washing or change / abort the time preselection.
• Load washing: Press the button O/s (START/PAUSE). The door can
be opened. Then close the door and again press the button O/s
(START/PAUSE).
• Change or abort time preselection: Press the button b (DELAY TI-
MER) as often as necessary until the required time is displayed; When
the program duration is displayed (shown in minutes, e. g. 125), the
washing program starts without a delay.
3
While the time delay is running, the washing machine switches to
Stand-by mode. Only X (DURATION) is illuminated from behind. The
multidisplay shows the remaining time until the program start. All
other displays on the control panel are switched off in order to save en-
ergy. Pressing any arbitrary button cancels the stand-by mode.
