Run wash cycle
63
Washing cycle finished/Removing the washing
If o (Rinse Hold) was selected:
0 After a rinse hold, the water first has to be pumped out:
– Either press the X/ (Start/Pause) button (the washing is spun in
accordance with the program which has just run; with the final spin
speed button/o (Rinse Hold) the spin speed can also be changed
whilst the washing is being spun),
or
– turn the program selector to C (Pump out) and press the X/ (Start/
Pause) button (the water is pumped out without the washing being
spun),
or
– turn the program selector to D (Spin) or F (Short spin) and press the
X/ (Start/Pause) button (the washing is spun or spun gently).
After this program step has been completed the (End) lamp is illu-
minated.
0 Open the door.
As soon as the (Door) display is green the door can be opened.
0 Turn the program selector to (Off).
0 Remove the washing.
0 After the program has finished, pull the washing powder compartment
out a little so that it can dry. Only lean the door to so that the washing
machine can get some air.
3
If the Å (Overdosing) display lights up it shows that in the washing
program which has just run too much washing powder was used and
due to this reason an extra rinse was carried out. For the next wash fol-
low the dosage instructions of the washing powder producer and the
load!
