Produkty značky Liebherr

Setting up

•Avoidlocatingtheapplianceitindirectsunlightornearheatsourcessuchasanoven

or a radiator.

•Theoorshouldbelevelandeven.Youcancompensateforanunevenoorbyad-

justing the adjustable feet.

•StandardEN378speciesthattheroominwhichyouinstallyourappliancemust

have a volume of 1 m

per 8 g of R 600a refrigerant used in the appliance, so as to

avoid the formation of inﬂammable gas/air mixtures in the room where the appliance

is located in the event of a leak in the refrigerant circuit. The quantity of refrigerant

used in your appliance is indicated on the type plate on the inside of the appliance.

•Theapplianceissettooperatewithinspecicambienttemperaturelimitsaccording

to its climate rating. These temperature limits should not be exceeded. The correct

climate rating for your appliance is indicated on the type plate.

 SN=+10°Cto+32°C

 SN-ST=+10°Cto+38°C

Electrical requirement

Power supply (AC) and voltage at the operating point must comply with the details on

the type plate. The type plate is located on the top left-hand side on the inside of the

appliance. The socket must be fused with a 10 A fuse or higher, it must be away from

the rear of the appliance and must be easily accessible.

Fitting dimensions (mm)

•Adjusttorecessheightusingthe4

adjustable feet on the underside of the

appliance.

•Connecttheappliancetothemains.

•Slidetheapplianceintotherecess.

•Securetheapplianceintherecessus-

ing 4 x 14 screws.

Installation and ﬁtting

The ventilation cross-section in the plinth panel must be min. 300 cm².