EZ1105 / EZ1305 User Manual
4-2. Installing the Ethernet module
3
Connection cable (module to
motherboard)
Fastening screw (1 screw)
【
】
Please make sure that you take precautions to prevent electrostatic discharge during
1. Make sure that the printer is
switched off and the power cord
disconnected from the printer. You
should work on a clean, flat surface.
Turn the printer upside down and
remove the three screws marked in
the illustration from the printer
housing.
Pull the bottom part of the housing
upwards to remove it as shown in the
illustration.
3. Hold the motherboard by the back
panel and pull it up. Then turn it over
and place it on the print mechanism
face down.
4. To remove the motherboard back
panel, unscrew the earthing screw
and the back panel fastening screw.
