DTC
06
I/M
YES
Menu:
1. DTC
NO
CODES
FAULT: 03
PEND: 03
If a
"LINK ERROR!"
message shows up, turn the ignition off for
about 10 seconds, check if the Scan Tool's OBDII connector is securely
connected to the vehicle s DLC, and then turn the ignition back to on.
Repeat the procedure from step 5. If the
"LINK ERROR"
message
does not go away, then there may be problems for the Scan Tool to
communicate with the vehicle.
6) Wait for the main menu to come up after a brief overview displaying
the scanning results with the total number of
DTC
s and the overall I/M
Monitor Status.
7) Select "
DTC
" from the main menu by pressing the
ENTER
button.
If there are no Diagnostic Trouble Codes retrieved, the display will
indicate
"NO CODES"
.
If there are any Diagnostic Trouble Codes, then the total number of the
Fault Codes followed by that of the Pending Codes will be reported on the
display.
8) Read the Diagnostic Trouble Codes by pressing the
SCROLL
button.
The first code number will display on the first line of the LCD display,
the numerical sequence of the code and the total number of the codes
