13
1. Check the filters
Ensure they are clean and properly positioned
(see "Maintenance and cleaning").
2. Press the On/Off push button
The On/Off indicator light comes on.
3. Check that there is rinse aid
and salt
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the
plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5. Ensure that the spray arms can
rotate freely.
6. Measure out detergent
Add the required amount of detergent into the
dispenser according to the dosage quantity
given in the "Washing programmes" chart.
Close the detergent dispenser lid.
7. Set the programme
The selection of a programme occurs with the
door partially opened.
Press the programme push button which
corresponds to the washing programme you
wish to select, the corresponding indicator light
will flash.
8. Start the programme
Close the door.
An audible signal advises you that the
programme has started.
The indicator light which corresponds to the
programme under way is now permanently on.
9. At the end of the washing
programme
At the end of the programme the
dishwasher will automatically stop and an
audible signal informs you that the
programme has finished.
The "end of cycle" indicator light flashes.
The "On/Off" indicator light remains on
until the On/Off push button is depressed.
Wait until the end of the audible signal
before opening the door.
10. Switch off the dishwasher
Open the door and switch off the
dishwasher by pressing the On/Off push
button.
Wait a few minutes before removing the
dishes; in this way they will be cooler and
the drying will be improved.
Empty the lower basket first and then the
upper one; this will avoid water dripping
from the upper basket onto the dishes in the
lower one.
11. Cancel the programme
To change a programme in progress, open
the door and press the push button
corresponding to the programme you wish
to cancel for about 1 second, until the
corresponding indicator light goes out.
The dishwasher is now reset and you can
select a new programme.
When the washing programme has
finished, it is recommended that the
dishwasher is unplugged and the water
tap turned off.
In general it is not advisable to open the
door while the machine is working; if the
door is opened however, a safety device
ensures that the machine stops.
Important!
Care must be taken if the door is opened
during the hot phase or immediately
after a programme has finished, as
steam may escape.
SEQ25en
Operating sequence