Problem Possible cause Possible solution
The water tap is clogged or there is
limescale on it.
Clean the water tap.
The filter in the water inlet hose is
clogged.
Clean the filter.
The water inlet hose has a kink or a
bend.
Make sure that the position of the
hose is correct.
The anti-flood device is on. There are
water leakages in the appliance.
Close the water tap and contact the
Service.
The appliance does not
drain the water.
The sink spigot is clogged. Clean the sink spigot.
The water drain hose has a kink or a
bend.
Make sure that the position of the
hose is correct.
After the checks are completed, activate the
appliance. The programme continues from the
point of interruption.
If the problem occurs again, contact the Serv-
ice.
If other alarm codes show, contact the Service.
The washing results and drying results are not satisfactory
Problem Possible cause Possible solution
The dishes are not clean. The filters are clogged. Clean the filters.
The filters are not correctly assem-
bled and installed.
Make sure that the filters are correctly
assembled and installed.
The spray arms are clogged. Remove remaining soil with a thin
pointed object.
The programme was not applicable
for the type of load and soil.
Make sure that the programme is ap-
plicable for the type of load and soil.
Incorrect position of the items in the
baskets. Water could not wash all
items.
Make sure that the position of the
items in the baskets is correct and that
the water can easily wash all items.
The spray arms could not turn freely. Make sure that the position of the
items in the baskets is correct and
does not cause the blockage of the
spray arms.
The quantity of detergent was not
sufficient.
Make sure that you add the correct
quantity of detergent in the dispenser
before you start a programme.
There was no detergent in the deter-
gent dispenser.
Make sure that you add detergent in
the dispenser before you start a pro-
gramme.
Limescale particles on the
dishes.
The salt container is empty. Make sure that there is dishwasher salt
in the salt container.
The set level of the water softener is
incorrect.
Make sure that the set level of the wa-
ter softener agrees with the water
hardness in your area.
12
www.zanussi.com
