A
D
5
Put filter (A) to its ini-
tial position. Make
sure that it assembles
correctly under the
two guides (D).
6
Assemble filters (B)
and (C). Put them in-
to position in filter
(A). Turn the handle
clockwise until it
locks.
An incorrect position of the filters can
cause bad washing results and damage to
the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged, re-
move remaining parts of soil with a thin pointed
object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use abra-
sive products, abrasive cleaning pads or sol-
vents.
Troubleshooting
The appliance does not start or it stops during
operation.
First try to find a solution to the problem (refer
to the table). If not, contact the Service.
With some problems, some indicators
flash continuously and/or intermittently
at the same time to show an alarm code.
Alarm code Problem
• The indicator of the set programme flashes contin-
uously.
• The end indicator flashes 1 time intermittently.
The appliance does not fill with water.
• The indicator of the set programme flashes contin-
uously.
• The end indicator flashes 2 times intermittently.
The appliance does not drain the water.
• The indicator of the set programme flashes contin-
uously.
• The end indicator flashes 3 times intermittently.
The anti-flood device is on.
Warning! Deactivate the appliance before
you do the check.
Problem Possible cause Possible solution
The programme does not
start.
The mains plug is not connected in
the mains socket.
Connect the mains plug.
The appliance door is open. Close the appliance door.
The fuse in the fuse box is damaged. Replace the fuse.
The appliance does not fill
with water.
The water tap is closed. Open the water tap.
The water pressure is too low. Contact your local water authority.
11
www.zanussi.com
