CM-80/80E INSTRUCTION MANUAL ULTRA
★
STEREO LABS, INC.
- 5 -
You Will Need to Supply the Following Materials:
• Shielded audio cable for connecting the CM-80/80E to the
cinema processor and power amplifier outputs.
• Four 10-32 x 1/2" screws to mount the CM-80/80E in the
audio equipment rack.
• For the CM-80E only - 16ga. two conductor wire for lengths
up to 15ft., 14ga. up to 30ft.
FEATURES
All CM-80 and CM-80E monitors have the following
standard features:
• 8-Channel Monitoring - allows you to monitor both the
processor and power amplifier outputs to Left, Left Center,
Center, Right Center, Right, Surround Left, Surround Right
and Subwoofer channels, in any combination.
• Input levels from processor and power amplifier can be
adjusted independently - no huge level jumps when
switching between processor and power amplifiers.
• Bargraph display may be calibrated to the reference level for
your theatre - the projectionist can see auditorium levels
instantly.
• Designed to work with Bi or Tri- Amplified Sound Systems
to monitor the high, mid & low frequency outputs from the
left, left center, center, right center and right channels.
The CM-80E has the following additional features
• Plug-in DC Regulated Exciter Supply module – the entire
Exciter Supply may be replaced in seconds.
• Front panel bypass mode switch that switches the Exciter
Supply to a 5 or 8 volt AC power source in the event of a
failure of the DC Exciter Supply.
• Front panel status LEDs indicate power going into and
coming from the Exciter Supply module.
