CM-80/80E INSTRUCTION MANUAL ULTRA
★
STEREO LABS, INC.
- 4 -
Introduction
Please read this entire manual before commencing your
installation.
The ULTRA
★
STEREO CM-80 Projection Booth Monitor and
CM-80E Monitor/Exciter Supply have been designed for high
performance, ease of use, and years of trouble free service.
Installation and setup of the monitors has been considerably
simplified. No special tools are required. The built-in VU
meter and test jack gives the technician immediate information
about the status of the processor and all power amplifiers. All
controls necessary for daily operation of the processor are
easily accessible on the front panel.
The components that make up the CM-80/80E monitors are of
computer grade for reliability. All front panel controls are
individually sealed for long life. All ULTRA
★
STEREO equipment
has been “burned-in” at the factory for an extended period in
order to eliminate the possibility of premature failure.
Unpack the unit carefully. If the container has been damaged,
thoroughly inspect the equipment to make certain that there is
no hidden damage. File a claim immediately with the carrier
if any damage is found. Also advise your dealer or the factory.
TOOLS REQUIRED
DC voltmeter
DC
No. 2 phillips
screwdriver
Wire strippers
Trimpot
adjustment
tool
