INTRODUCTION
MINI 97MY
1.5
Disciplines
Switch off ignition prior to making any connection or disconnection in the system
as electrical surge caused by disconnecting 'live' connections can damage
electronic components.
Ensure hands and work surfaces are clean and free of grease, swarf, etc. as
grease collects dirt which can cause tracking or high-resistance contacts.
When handling printed circuit boards, treat them as you would a disc - hold by
the edges only; note that some electronic components are susceptible to body
static.
Connectors should never be subjected to forced removal or refit, especially inter-
board connectors, damaged contacts will cause short-circuit and open-circuit
conditions.
Prior to commencing test, and periodically during test, touch a good earth, i.e.
cigar lighter socket, to discharge body static as some electronic components are
vulnerable to static electricity.
Grease for electrical connectors
All under bonnet and under body connectors are protected against corrosion by
the application of a special grease on production. Should connectors be
disturbed in service or repaired or replaced, a grease of this type, available
under Part No. BAU 5811, should again be applied.
NOTE: The use of other greases must be avoided as they can
migrate into relays, switches etc. contaminating the contacts and
leading to intermittent operation or failure.
