Remote Control Operation
4. Recall Button
Press the Recall button to activate the on-screen
display.
The current Programme Number, Sound System,
Colour System, Surround mode and Sound
output mode (depending on type of broadcasting
transmission system ) will be displayed on
the screen.
After few seconds, the on-screen display of
Sound System, Colour System, Surround mode
and Sound output will disappear autamatically.
Press it again to cancel the current Programme
Number.
---------------------------
1
4.5 MHr MONO
AUTO
<>
r
1
MONO SURROUND
N
______
_
_______
J
________
J
First push
After few seconds
Note : In the AV mode, a blue colour screen
appear, if there is no AV signal, when
the recall function is off.
5. Normalization (NORM.) Button
NORM.
%
This button can be used for setting the Colour,
Tint {Auto, NTSC only), Brightness, Contrast,
Sharpness, Bass, Treble and Balance.
When this button is pressed, all functions
setting are normalized or reset to the factory
preset level (is showed in yellow colour).
e.g. When this button is pressed after adjusting
colour function.
green colour yellow colour
6. Picture Control Function (P)
Button
%
By pressing the Picture Control Function
button repeatedly, the on-screen display will
be changed as shown below.
COLOUR—► NTSC-TINT—►BRlGHT-i
SHARPNESS- CONTRAST-
Press the Volume Up" + ” or Down ” -" buttons
during display to adjust the level selected function
Note:
NTSC -TINT will appear on the screen
if AUTO and NTSC 4.43 or NTSC 3.58
is selected.
19.
