VikinX Sublime Control Panels Rev. M
nevion.com | 18
6 GPI connections
This information is only applicable on GPI versions.
The GPI / Joystick / Tally signals are connected to the Sublime Control Panel with GPI
options using DB25 male connectors. Each Sublime CP with GPI I/O has 32 GPI inputs and
32 GPI outputs available, independent of panel size.
The GPI connectors on the CP are DB25 females.
The following pin-out applies:
Inputs are internally connected to +5V via a pull-up resistor. The inputs will be activated
when pulling them to ground. Ground is available on the following pins: 2, 5, 8, 11, 13,
16, 19, 22, 25 and on the connector chassis.
Outputs are of open collector type. An output can switch a maximum load of 100mA at
30V. Any device to be controlled by the GPI outputs (lamp, LED or similar) needs to be
connected to an external supply voltage on one end and to the GPI output on the other
end.
Warning! Do not connect external supply voltages higher than 30V DC.
