VikinX Sublime Control Panels Rev. M
nevion.com | 12
4 LED status indication
4.1 Start-up
The LED located at the front of the control panel indicates the status of the panel. At start-
up, the LED will alternate between red (R) and green (G) every 500ms for about two
seconds. After the start-up sequence the LED will indicate the Alarm state of the panel.
There are two LEDs located at the Ethernet bus. At start-up the boot loader is searching for
update commands on the serial port for about two seconds. During this sequence both
Ethernet LEDs will be blinking. After the start-up sequence the LEDs will indicate the
Ethernet state.
4.2 Alarm states
The LED can either be red (R), green (G), yellow (Y) or have no light (N).
The LED state is here described with twenty letters, each representing 100ms, which totals
to an alarm sequence of two seconds. The X indicates that the LED keeps the color it has
the moment the alarm sequence begins (green, yellow or no light).
Unable to
connect to
controller
over
Ethernet.
This alarm will be
overwritten by other
alarms
Only active if power
alarm dip is set.
Only active if power
alarm dip is set.
Red with one
short yellow
blink
4.3 Ethernet states
The LEDs that are located at the Ethernet bus will after the Start-up sequence indicate the
Ethernet states:
Data is transmitted or received
