Connect to a network with Windows
Supported network protocols
To connect a networking-equipped product to a network, you need a network that uses one or more
of the following protocols.
●
TCP/IP (IPv4 or IPv6)
●
LPD Printing
●
SLP
● WS-Discovery
Install the product on a wired network with Windows
NOTE: Use this procedure if you are not using the HP Smart Install.
Obtain the IP address
1. Connect the network cable to the product and to the network. Turn the product on.
2. Wait for 60 seconds before continuing. During this time, the network recognizes the product and
assigns an IP address or host name for the product.
3.
At the product control panel, press the Setup
button.
4. Touch the Reports menu, and then touch the Configuration Report button to print the
configuration report.
ENWW
Connect to a network with Windows
65
