17
Messages In The Display
“Demo” will slide across the display when the
Demonstration mode has been accidentally activated.
Follow the instructions below to cancel “Demo” mode:
Step 1:
Press & hold simultaneously the “On/Off button” and “Start/
Reset button”, until “D of” is illuminated in the display.
Step 2:
Select wash programme as normal
-DEMO Lit in Display
- Possible Filter Blockage
-AL05 in Display
- Demonstration mode
actived
- If AL05 is illuminated in the display, then you need to
clear the filter of any blockages before programme can
proceed.
Step 1: Press & hold the “On/Off button”, until 4 dashes
are illuminated in the display.
Step 2: Remove filter from base of machine.
Step 3: Rinse filters under running water and ensure that
large food particles are removed from Area A.
Step 4: Locate filters back into the filter housing and firmly
press downwards.
Step 5: Turn the dishwasher on by pressing the “On/Off”
button, and select required programme.
Poor Wash Results
Residue On Dishes When
Wash Cycle Complete
For additional advice on Cleaning your filter see “Care and
Cleaning” section of the instruction book.
-Is the selected programme suitable for the type of load
and the degree of soiling?
-Check the loading of your crockery into the baskets (See
“Loading You Dishwasher” Section of the instruction book).
-Check that the filters are clean and in place (See “Care
and Cleaning” Section of the instruction book.
-Is the lid of the salt container closed properly?
Fault Area
Issue
Cause/How to resolve…
-Is the rinse aid dosage correct?
(See section “Poor Drying Results” below for instructions
on adding or adjusting rinse aid to your wash).
1
2
A
B
C
On/off
Button
Start/Reset
Button
On/off
Button
