This configuration is used to enable a set of contacts whenever a
designated line is put on hold. Use this feature when you need to operate
a lamp or other remote indicator to show a call has been put on hold.
Action
Step 1: Apply power or disconnect and reapply.
The LED will flash rapidly and you have 20 seconds to
commence programming.
Step 2: Press the and then press
Step 3: On your dial pad depress the numbers that correspond with
the line keys on which you want to indicate a Hold condition.
See Fig.1, page 6.
Step 4: Press the
Step 5: Press to enter this configuration.
For example, if you need line buttons 1, 3, 4 and 5 plus all the lines on the
add-on module to operate the contact closure whenever they have been
put on hold, the following keys would be pressed:
Note:
If you have chosen to enable the contacts, they will now operate
whenever their associated LCDs are in Wink state. The contacts are
opened when none of their associated LCDs are in Wink state or there is
a Hard Reset or a Soft Reset from the Central Office.
29
Configuration 11
Hold Detect
#
9 3
1
*
*
##9 3 11 3 4 5
* *
