This configuration is used to give an audible alert for lines which have
been put on hold. The Hold Reminder ringing can be timed from 20-99
seconds. If a line has been put on hold at any station and the line
appears on the programmed station the Hold Reminder ringing will be
activated. On the MBS any or all lines may be programmed to ring. On an
add-on module either all or no lines can be programmed to ring. Ringing
is a split ringing cadence with standard ringing frequencies.
Action
Step 1: Apply power or disconnect and the reapply.
The LED will flash rapidly and you have 20 seconds to
commence programming.
Step 2: Press the and then press
Step 3: Enter the time in seconds to expire before the Hold Reminder
ringing starts. This field must be two digits long, e.g., 25 = 25
seconds.
Step 4: Enter the line number or numbers which are to respond to the
Hold Reminder feature. The # key will select all add-on module
lines.
Step 5: Press the
Step 6: Press to enter this configuration.
For example, if you want to program line buttons 1 to 4 to start ringing 25
seconds after they have been put on hold, the following keys would be
pressed:
Or, if you want to program lines 1 and 2 and all lines on the add-on
module to start ringing 40 seconds after being put on hold, the following
keys would be pressed:
28
Configuration 10
Hold Reminder
Alert Tones
*
#9 2 12 5 1 2 3 4
9 2
*
# 1
* *
##9 2 14 0 1 2
* *
