Command Reference Manual
100722A
Conexant
3-5
3.2.1.7 I - Identification
This command causes the modem to reports the requested result according to the command parameter.
Syntax
I<value>
Defined Values
<value> Decimal number corresponding to the selected information.
0 Reports product code, e.g., “56000”.
1 Reports the least significant byte of the stored checksum in decimal (see firmware
release notes). Reports 255 if the prestored checksum value is FFh.
2 Reports "OK".
3 Reports identification codes in the form RevisionName-Modulation_Model, where:
RevisionName = Product family name_firmware version. The product family
name is ACF3 for SmartSCM, SmartACFL, and SmartSCM.
The firmware version is in the form VX.XXX. For example:
ACF3_V1.200
Modulation = V90, V34, or V32 for V.90, V.34, or V.32bis, respectively
Model = Typical models are:
2M_SCF Serial and parallel interface in ROM
2M_RAM_SCF Serial and parallel interface in RAM.
1M_RAM_SCF Serial and parallel interface in 1M RAM
Examples: ACF3_V1.200-V90_2M_SCF
ACF3_V1.200-V34_1M_RAM_SCF
NOTE:
If RPI+ is enabled (see +Hn command),
“ROCKWELL RPI (TM)+01” is appended.
4 Reports OEM defined identifier string in either Hayes-compatible binary format
(default) or ASCII format (selectable by ConfigurACE), e.g.:
a007040284C6002F
bC60000000
r1005111151012000
r3000111170000000
5 Reports Country Code parameter (see +GCI command), e.g., B5.
6 Reports modem data pump model and internal code revision, e.g.,
“RCV56DPF-PLL L8773A Rev 14.00/34.00”.
7 Reports “OK”.
Result Codes
OK <value> = 0 - 7.
ERROR Otherwise.
3.2.1.8 +GMI - Request Manufacturer Identification
This command causes the modem to report the modem product manufacturer.
Syntax
+GMI
Typical Response
+GMI: CONEXANT
OK
