2.6 Ball head holder installation
Fold out folded page 2-57
coupé only
A
Open the side covers (1) and remove the floor cover (2).
coupé only
B
Undo the bolt (3) and then install the holding bar (4) using the bolt (3).
Replace the floor cover, threading the straps (5) up and around the edge of the floor cover.
The holding bar (4) must be installed in such a way that the buckle for the strap (5) points to the outside.
coupé only
C
Place the ball head bar (6) into the ball head bag (7) and close the zip fastener.
coupé only
D
Position the ball head bag (8) at the rear right-hand side of the car and thread the strap (9) through the lug (10).
Thread the end of the strap through the buckle (11) and tighten the strap (9).
roadster only
E
Find the position of the screw connection behind the interior trim using a bradawl or the like. Cut out the interior
trim (12) around the screw connection.
roadster only
F
Secure the ball head holder (13) with the bolts (14).
roadster only
G
Insert the ball head and close the strap buckle (16).
Ensure that the ball head bar is secure. Check that the strap buckle to ensure it functions correctly.
2-50/EN
