Replace control unit
103 Relay - EGS control unit 52 Relay in EGS not switching in time
104 Engine over-rev lock Engine speed >6800 rpm detected
105 Speed monitoring
Trans/engine speed ratio not correct for gear selected
Speed sensor signal faulty
Slip in transmission too high
106 Speed monitoring
Trans/engine speed ratio not correct for gear selected
Speed sensor signal faulty
Slip in transmission too high
(150) CAN timeout 1 CAN signal not sent during engine start (ignition on)
(151) CAN timeout 2 CAN signal not detected (engine running)
(152) CAN bus monitor Values in CAN ram storage not updated
(153) CAN status fault Control units with different CAN status' are installed on
the same bus
Replace with correct units
(154) CAN throttle valve signal Anomalous throttle valve signal detected by DME
(155) CAN load signal Anomalous load signal detected by DME
(156) CAN engine intervention
DME cannot alter engine torque to match EGS signal
DME does not match other CAN control units (e.g. ASC)
(157) CAN engine temperature Anomalous engine temperature signal detected by DME
Top
Copyright - Baum Tools Unlimited Inc. Aug. 25, 1997
32 of 32 11/15/00 9:55 AM
bmwcodes http://www.baumtools.com/bmwcodes.htm
