bintec RV120w-4G
09.12.2014
Subject to technical alterations
Page 9 / 11
bintec elmeg GmbH - Suedwestpark 94 - 90449 Nuremberg - Germany
Phone: +49 - 911 9673-0 - Telefax: +49 - 911 688 07 25
Hardware
Environment High temperature range: Operational -30°C to +70°C
Power supply Optimized for the operation from a 12 Volt or 24 Volt vehicle battery. Automatic time delayed
switch off via ignition control input possible.
Dimension Ca. 200 mm x 62 mm x 165 mm (W x H x D)
Weight 1,5 kg
Fan Fanless design therefore high MTBF
Reset button Restart or reset to factory state possible
Status LEDs Power/Status, 8 * Ethernet
Scope of supply
Power supply connector (M12), Ethernet cable, Consolport-cable D-Submin 9-pin, wall mounting,
Docu-CD, Installation flyer d/en
Accessories
RV Starterkit (5520000132) 2x WLAN antenna, 2x 4G/3G antenna, GPS antenna, Power supply 100-240V
GPS Functionality
Display of the position Display of the current location as coordinates and as Google Map
Event Manager Definition of one or multiple geographical aeras for triggering an event. This function allow a
re-configuration of the unit from the WLAN AP mode to the WLAN client mode in the case that the
vehicle is reaching the bus depot.
WLAN Access Point Operation Mode
Broadcast SSID On/off switchable
Bandwidth (802.11n) 20/40 MHz (bundling of two adjoining 20 MHz channels to one 40 MHz channel)
Short guard interval (802.11n) On/off switchable; increase of throughput by reduction of the guard intervals from 800ns to 400ns
Multi SSID Up to 8 service sets per radio module, with virtual access points and own MAC address per SSID
and assignment to a VLAN
VLAN Network segments on layer2 possible. Per SSID one VLAN ID available. Static VLAN configuration
according IEEE 802.1q; up to 32 VLANs supported.
Selection of the radio channel Manuell or automatic channel selection
WMM 802.11e QoS Data prioritization for TOS data, 802.11e/WMM
WMM 802.11e Power Save Support of active WLAN clients, which support 802.11e power save
U-APSD Unscheduled Automatic Power Save Delivery: this functionality contributes significantly to raise
battery life of Voice-over-WLAN end devices
Roaming (access point mode) Seamless roaming with IAPP (artem Inter Access Point Protocol)
