6 D-302754 PowerMaxComplete Installer's Guide
ZONE 29 & SIREN WIRING
MAGNETIC CONTACT
OR ANY OTHER
CONTACT
(NOT A DETECTOR)
SITE EXTERNAL SIREN
MG ELECTRONICS
MG441PDS OR SIMILAR
12 VDC SIREN
Alarm
N.C.
2.2 k
Ω
OPTIONAL EXPANDER MODULE
ZONES, SIRENS, AUDIO BOX AND WIRED DETECTORS WIRING
MIC SPK GND PGM
EXT.-
12V
SRN+ IN.-
Z29 GND Z30
SITE
INTERNAL
SIREN OR
STROBE
SITE EXTERNAL
SIREN MG441PDS
OR SIMILAR
12 VDC SIREN
EXPANDER
VOICE BOX
Note
Regarding zones 29 & 30, the Control
Panel “sees” a specific resistance
according to the event, as follows:
Normal
(no alarm & no tamper): 2.2 k
Ω
Alarm event
: 4.4 k
Ω
Tamper event
: Infinite resistance
CONNECT WIRED DETECTORS AS FOLLOWS:
(*)
Power
ZONE 29 /
ZONE 30 GND
TAMP
N.C.
12V
(*)
Alarm
N.C.
ZONE 29 /
ZONE 30
Power
GND
2.2 k
Ω
12V
Alarm
N.C.
Detector with
Tamper switch
Detector without
Tamper switch
Note
The EXPANDER module
is an optional module.
If this optional module is
not used, a small 4-
terminal strip is used
instead (2 terminals for
zone 29 and 2 terminals
for siren).
Caution:
When using the Expander,
the internal siren and
Zone 29 must be wired
via the Expander
and not via the
control panel.
Figure 3.2 - Wiring
Notes for EXPANDER module wiring:
* Zone 29/GND and Zone 30/GND terminals can be
connected to a normally closed contact of a detector,
switch (for example a Tamper switch of any device), or
a pushbutton, via a 2.2 K
Ω
resistor. The 12V terminal
can be used to supply 12V (up to 36mA) to a
detector (if necessary).
** The EXT terminal can be used to trigger an external siren.
The INT terminal can be programmed for an "internal
siren" or "strobe" (see DEFINE OUTPUTS - DEFINE
INT/STRB in par. 4.8).
The 12V and "GND" terminals can be connected to a
siren (for constant DC power supply).
WARNING! When plugging terminals back into place, be
sure to align them carefully with the pins on the PCB.
Misaligned or reverse insertion of terminals may damage
internal PowerMaxComplete circuits!
IMPORTANT! The terminals for internal and external
sirens are DC outputs intended for 12V sirens. Connecting
a loudspeaker to any of these outputs will cause a short
circuit and will damage the unit.
