25
Aspect Ratio Controls
» Aspect Ratio Operation with Computer Signals
Switch to the wide screen mode to expand the 4:3 image to ll the entire screen.
1. Press the ASPECT button on the remote control.
2. Within 3 seconds...
Press the ASPECT button again. The screen size switches as follows:
STD (4:3) ANAMORPHIC LETTERBOX
STD 4:3 mode (4:3 or SXGA 5:4)
The picture has the same size as the normal computer image.
ANAMORPHIC mode
The image is expanded in the horizontal direction.
LETTERBOX mode
When wide signals are input.
NOTE:
Do not leave the displayed in 4:3 mode for an extended period.
This can cause a phosphor burn-in.
Information
■ Supported resolution
See page 58 for details on the display output of the various VESA signal
standards supported by the monitor.
■ When 853 (848) dot x 480 line wide VGA *signals with a vertical
frequency of 60 Hz and horizontal frequency of 31.7 (31.0) kHz are
input.
Select an appropriate setting for RGB SELECT mode referring to the
“Table of Signals Supported” on page 58.
* “IBM PC/AT” and “VGA” are registered trademarks of IBM, Inc. of
the United States.
