Unit Configuration
BreezeCONFIG for BreezeACCESS VL and BreezeACCES 4900 User Manual
74
algorithm. If the Adaptive Modulation algorithm is disabled, it sets the fixed
modulation level to be used.
Multicast Modulation Level (AU only): The modulation level for
transmission of multicast and broadcast data frames. Since multicast and
broadcast transmissions are not acknowledged, it is recommended to set a
low modulation level to ensure transmission without error.
Burst Mode Option: From the dropdown menu, select whether to Enable or
Disable the Burst Mode operation. Burst mode provides an increased
throughput by reducing the overhead associated with transmissions in the
wireless medium.
NOTE
The Burst Mode parameters are not applicable when the Wireless Link Prioritization Option is
enabled.
Burst Interval: The Burst Interval defines the burst size, which is the time in
which data frames are sent immediately without contending for the wireless
medium. The available values depend on the Sub-Band (Country Code).
Concatenation Option: The Concatenation Option enables or disables the
packet concatenation mechanism.
Maximum Concatenated Frame Size: The Maximum Concatenated Frame
Size parameter defines the maximum size (in bytes) for a concatenated frame.
The range is:
256 to 2200 bytes for units with HW revision A or B.
256 to 4032 bytes for units with HW revision C or higher.
2.8.1.1 Adaptive Modulation (Multi Rate)
Adaptive Modulation Option: From the dropdown menu, select whether to
Enable or Disable the adaptive modulation decision algorithm.
Minimum Interval Between Adaptive Modulation Messages: The minimum
permitted time, in seconds, between consecutive messages carrying
information regarding the quality (SNR) of received signals. Available values
range from 1 to 3600 seconds.
