ITG User’s Guide
Chapter 4 Configuring ITG from a Web Browser
This chapter explains procedures for configuring the ITG from the web browser.
4.1
Http setting mode
This
section
describes
the processes for setting up
Internet Telephony Gateway once it has been
installed. Microsoft Explorer version 4 or higher,
or
Navigator
version
4.5 or higher can be used
in this section to view
and change parameters.
PC Setup
In order to configure the ITG, PC needs to have TCP/IP protocol and a compatible IP Address.
1.
Connect the ITG to network with a RJ-45 UTP cable. Power it on.
2.
Find a PC, for example, Windows 95/98. Under Windows 95/98, select the
Network
Neighborhood
icon on the desktop, then select
Properties
. We will see a screen like below:
3. If a line like the one highlighted ("TCP/IP -> Network Card”) is not listed , select A
dd-
Protocol-Microsoft-TCP/IP-OK
to add it.
4. Select
Properties
for the “TCP / IP -> Network card” entry. You will see a screen like the
following:
5. On the
IP Address
table, enter values as follows:
18
Configuring ITG from a Web Browser
