R
(FM10) SEMCON LAND ROVER OWNER GUIDE VER 2.00 EURO
LANGUAGE: english-en; MARQUE: landrover; MODEL: Range
Rover Evoque
Entering the vehicle
11
Note: If a tailgate button is pressed while the
tailgate is opening or closing, all movement will
stop. However, if a button is pressed during the
'soft close’ stage, the open request will be
ignored.
Before operating the tailgate, make
sure anyone in the vicinity does not
have any part of their body in a
position where it could be trapped.
Note that the 'soft close’ action does
not incorporate object detection.
Death or serious injury could occur,
even with an object detection system.
Object detection while opening: If an object is
detected that would interfere with the tailgate
opening, tailgate movement will stop. Remove
any obstructions and press the tailgate button
again to open.
Object detection while closing: If an object is
detected that would interfere with the tailgate
closing, tailgate movement will stop and then
reverse to the fully open position. An audible
warning will be given to indicate a mislock.
Remove any obstructions and press the
tailgate close button again to close.
TAILGATE OPENING HEIGHT
The maximum opening height can be set as
required. This is useful in parking areas with
low ceiling heights or just for ease of use.
1. Open the tailgate to the position which you
want to set as the maximum height. Press
any tailgate control to stop movement at
the required position. Final position can be
achieved manually if required.
2. Make sure the tailgate is stationary for at
least 3 seconds.
3. Press and hold the tailgate close switch for
10 seconds to set the maximum opening
height.
4. Close the tailgate, then open again to check
that it opens to the programmed height.
Note: If, after performing part 3 of the process
the tailgate closes automatically, the required
height has not been set. Repeat the process
making sure that all steps are adhered to.
To reset the maximum opening height, repeat
the process, but when the tailgate reaches its
current programmed height, manually move it
to the fully open position before pressing and
holding the button.
The powered tailgate may lose its position
memory if there are multiple object detections
or if the battery voltage is low. Powered
operation may be inhibited.
To reset the tailgate:
1. Manually close the tailgate.
2. Press a release switch.
3. Allow the tailgate to power fully open or to
the previously set position.
4. Press and release the close switch.
5. Allow the tailgate to power close fully. The
tailgate programmed memory will now be
restored.
DRIVE-AWAY LOCKING
Drive-away locking automatically locks all
doors at a set speed when the vehicle is in
motion. This feature can be enabled/disabled
via Drive-away locking in the Vehicle set-up
menu. See 40, INSTRUMENT PANEL MENU.
SMART KEY BATTERY
REPLACEMENT
When the battery needs replacing, there will be
a significant decrease in the effective range and
SMART KEY BATTERY LOW will be displayed
in the Message centre.
