About connecting modules 3-17
Chapter 3: Setting Up the Wave IP 500 Server
Wave Server Installation Guide
• 90° cable—The cable comes out of the side of the connector and then makes a 90°
turn.
You can connect a 90° cable on only one side using a screw. On the other side, use a
tie down on the module or card to secure the cable to the board with a tie wrap.
2. Make sure that the cables are securely connected. The tabs on modular connectors click
in when the cables are secure. Secure the cable to an RJ-21X connector with the cable
strap.
About connecting specific modules
See the following sections for information about connecting each of the supported modules:
• Analog trunk module. See page 3-18.
• Analog universal module. See page 3-18.
• Digital station module. See page 3-19.
• T1 module with serial interface. See page 3-20.
• E1 module with serial interface. See page page 3-22.
• Quad BRI module. See page 3-23.
Caution: Ensure that only analog phones are connected to analog station ports and only digital
phones to digital station ports. This will prevent damage to the analog circuitry.
Release 2.0 Service Pack 1
