About connecting modules 3-15
Chapter 3: Setting Up the Wave IP 500 Server
Wave Server Installation Guide
About connecting modules
This section provides general information about connecting trunks, stations, and other devices
to modules. Instructions for connecting specific modules are described in subsequent sections.
Important: Before connecting modules, ensure that the following tasks have been completed,
depending on your configuration:
• The punchdown block or patch panel has been properly wired.
• Analog and T1 trunks have been installed by your service provider.
• Incoming analog DID trunks have been tested to ensure no voltage is present, as well as
to verify that they are DID trunks.
About cable connections
Modules and cards use standard cable connectors and jacks, as listed in the following table:
Note: Some modular connectors look alike. Verify that your cables use the standard connectors
specified for a particular module.
Module RJ-11 RJ-21X RJ-45 RJ-48C 3.5 mm
audio
USB
Integrated Services
Card (ISC2)
41 23
Analog trunk module
1
Analog universal
module
1
Digital station module
1
T1 module with serial
interface
1
T1 module (without
serial interface)
1
E1 EuroISDN module
with serial interface
1
Quad BRI module
4
Release 2.0 Service Pack 1
