TABLE OF CONTENTS
I. GENERAL INFORMATION
-1-
I. GENERAL INFORMATION
a-Introduction 1
b-Operation 1
c-Cleaning 1
d-Applicable Models 1
e-Tool Requirements 1
f-Enable-Disable Label Printer 1
II. BASIC SERVICE PROCEDURES & ADJUSTMENTS
a-Check Record Printer Media 2
b-Check Label Printer Media 2
c-Loading The Printer Media 2
d-Running A Test Print 2
III. PRINTER COMPONENT DIAGRAM 2
IV. ADVANCE SERVICE PROCEDURES & ADJUSTMENTS
a-Cutting Wheel Operation 3
b-Check Printer Power-Basic 3
c-Check Printer Power-Advanced 3
d-Check Printer Data Harness 3
e-Interchange Instructions 3
V. FLOW CHART - SERVICE PROCEDURES
& ADJUSTMENTS 4
VI. SMARTCHILL
®
BOARD DIAGRAM 5
VII. TROUBLESHOOTING 6
I. a–INTRODUCTION:
A Traulsen Blast Chiller will come standard with one printer, the
record printer. All SmartChill
®
controls have the option to enable
or disable the use of a second printer, the label printer.
When facing the front of the unit the record printer is located in
the left printer housing and the label printer is in the right printer
housing.
Both printers, record and label, have the same part number
950-60355-00 and are interchangeable with the exception of
any RBC50 models manufactured prior to 2008, with 90
degree
printer boards in which case the part number is 950-60408-00.
I. b–OPERATION:
SmartChill
®
printers are thermal printers, meaning no ink is re-
quired. Upon receipt of a signal from the SmartChill
®
control,
the printers will print specied data. The record printer ONLY
uses 2 ¼” thermal paper and the label printer ONLY uses 2 ¼”
Traulsen thermal label stock part number 400-60004-00.
The record printer will print power on diagnostics information,
single batch data, and twelve hour data logs.
The label printer will print single batch product labels, that may
be applied on food containers.
I. c–CLEANING:
Dirt and debris can build up on the feed roller and cutting wheel
cartridge and impede normal operation. Clean only with electric
contact cleaner using a lint free cloth.
I. d–APPLICABLE MODELS:
This manual applies to the following Traulsen models:
RBC50 Undercounter Blast Chill Model
RBC100 Reach-In Blast Chill Model
RBC200 Roll-In Blast Chill Model
RBC200RT Roll-Thru Blast Chill Model
RBC400 Roll-In Blast Chill Model
RBC400RT Roll-Thru Blast Chill Model
NOTE: This manual refers to the above models built
after June 2003, equipped with the SmartChill
®
control.
For information regarding models built prior to that date
please contact the factory at 800-825-8220.
I. e–TOOL REQUIREMENTS:
• Basic hand tools
• AC/DC VOM
I. f–ENABLE-DISABLE LABEL PRINTER:
The FACTORY SETTINGS MODE allows service per-
sonnel to return various control settings to their factory
preset parameters.
