SCION xA 2006 - SECURITY WITH RKE (V3)
Procedure
Page 5 of 22 pages
Issue: C 05/24/05
DIO
(m) Remove the glove box. (Fig. 1-12)
2. Piezo Buzzer Installation.
(a) Using one large foam tape and one large wire
tie, secure the Piezo Buzzer to the vehicle's
harness near the vehicle's clip. (Fig. 2-1)
(1) Do not cover the opening of the Buzzer
with the foam tape.
(2) Ensure the Buzzer opening is facing
downward.
(b) Locate the gray 2P connector near the vehicle
grommet. (Fig. 2-2)
(1) Remove and discard the cap from the
gray 2P connector.
(c) Plug in the Piezo Buzzer harness gray 2P
connector to the vehicle harness gray 2P
connector. (Fig. 2-3)
(1) Verify the connectors are plugged in
securely.
(d) Using one large foam tape and one large wire
tie, secure the gray 2P connectors to the
vehicle harness. (Fig. 2-3)
Fig. 2-1
Side Cutter
Large Wire Tie
Large Foam Tape
Piezo Buzzer
Vehicle's Clip
Fig. 1-12
Glove Box
Fig. 2-2
Cap
2P (Gray)
Piezo Buzzer
Fig. 2-3
Side Cutter
2P (Gray)
Piezo Buzzer
Large Wire Tie
Large Foam Tape
